🔥 The Rail
Reported by AZBilliards Forum
•
1 hour ago
I had to order a cheap Thread Pitch Gauge, to measure the threads, and I learned today that this is a 10 Thread (per inch) joint pin. So, I assume it is 3/8×10.
I assumed that it would probably be 3/8×11, lol, because I have never seen a Brass plated 3/8×10 joint pin..
Anyways, it still does not look like a 3/8×10, so maybe a Modified 3/8×10?
All I know is that it is 10 Thread turns per inch though, as I previously thought, based on a measurement.
Anyways, I really need a shaft for…
This dispatch was curated from AZBilliards Forum.
Leave a Reply